Housings
Submersible probes ( SPO 41 and SPO 41MEK), flow - through probes (SPR 42 and SPR 41ME), insertion probe (SVK 42), flow-through units ( PB 42 , PB 43) and sensor sleeves (PE 3G/4D, K) serve as shelters for sensors for measurement of pH, ORP, O2 concentration, chlorine, ozone and other variables. The probes allow the operation of delicate electrochemical sensors under the harshest operating conditions in water treatment processing. The probes are designed for the installation of electro-chemical sensors of Ø12 or Ø15 mm, which are equipped with a standard collar for gripping and sealing.
The submersible probes are designed for measurement on open water surface, flow-through probes and flow-through units are connected to the measured medium by a tube through a closing valve installed in the pipe or tank. The insertion probe allows direct installation into the pipe. One or two input units are installed in the probe head (except for SVK 42).
A mechanism enabling effective sensor cleaning is built-in into SPO 41MEK and SPR 41ME.
Submersible probes can be also installed on PL 55 float, if it is necessary to measure in a deep shaft or on open water surface far from the shore or at high level fluctuation.
In Category Housings there are these products:
SPO 41 Submersible Probe
The probe is installed vertically or obliquely into open reservoirs, channels, and tanks...
SPO 41MEK Submersible Probe with Automatic Cleaning
One sensor Ø12/Ø15 x 115 mm with an implemented collar for gripping and sealing (and one temperature sensor) can be installed in the probe...
Submersible Probe SPO 42
The probe is installed vertically or obliquely into open reservoirs, channels, and tanks...
SPR 42 Flow-through Probe
This probe is used when the sample is taken from the tap installed on the pipe or tank...
SPO 41ME – Flow - through Probe with Automatic Cleaning
One sensorØ12/Ø15 x 115 mm with an implemented collar for gripping and sealing (and one temperature sensor) can be installed in the probe...
SVK 42 Insertion Probe
The probe is installed into the pipe or onto the reservoir wall. It is fixed by a cap nut with a thread of G 5/4" into the welded-on piece.
PB 42, 43 Flow-through Units
The PB 42V, PB 43V (PB 42, PB 43- without valve) flow-thru unit serves as a shelter for the pH, ORP, chlorine concentration and other sensors.
PE G3/4D, PE G3/4K Sensor Sleeves
Sensor sleeve is a simple cover for detecting elements measuring inside pipes and tanks.
