Ozone Analyzer MOZ 66
The analyzer can measure ozone concentration with one or two CSZT 43 sensors or ozone and pH value simultaneously. The sensors can be located at one point or at 2 different points up to 1,000-m distance from the analyzer.
Analyzer relay outputs can be used for two-position control of the ozone generator (generators). Analogue outputs can control ozone generator (generators) continuously.
Analyzer Specifications
| Measurement Range | - Ozone | 0.01 to 10.0 mg/l (ppm) |
|---|---|---|
| Sub Ranges (Analogue Output) | 1.0, 2.0, 5.0, 10.0 mg/l or other | |
| Measurement Range | - pH | 0.0 … 14.0 pH units |
| Sub Ranges (Analogue Output) | 0.0 – 14.0, 0.0 – 10.0, 2.0 – 12. | |
| 4.0 – 14.0. 2.0 – 7.0, 4.0 – 9.0, | ||
| 7.0 – 12.0 or other | ||
| Resolution | - Ozone | 0,001 mg/l |
| - pH | 0,01 | |
| Display | 2-line alphanumeric LCD readout, | |
| 16 digits per line | ||
| Output Signal | 0/4 - 20 mA | |
| Load | max 500 Ohm | |
| Temperature Compensation | automatic (both values) | |
| Basic Accuracy - Ozone | 5% of the range | |
| at constant temperature | ||
| Relay Outputs | none, 2 or 4 relays (high/low) | |
| (set points, hysteresis, delay - programmable) | ||
| voltage free contact, 250 V/50 Hz - max. 3 A | ||
| *24 Vss - max. 0,5 A | ||
| Time Delay | 0.0 ... 240 minutes | |
| Recommended pH Sensor | SEOJ 13, SEOJ 131, SEOJ 131K | |
| IP65 | ||
| Supply Voltage | 230 V, +6 -15 % 50/60 Hz | |
| Power | max. 20 VA | |
| Dimensions | 219 x 184 x 115 mm | |
| W x H x D | ||
| Weight | ca 1.5 kg | |
Ambient Conditions
| Temperature | 0 to +35°C |
|---|---|
| Relative Humidity | 10 to 90% |
| Barometric Pressure | 600 to 1060 hPa |
* Valid for resistance load
Dimensions (41.2 KB)
Print
